Screen Hard Copy Function; Outline Of Hardware Copy Operation - Mitsubishi F940GOT-SWD-E Operation Manual

Graphic Operation Terminal F940GOT
14.5

Screen hard copy function

The screen image being displayed can be output to a printer connected to the RS-232C inter-
face in the F940GOT.
14.5.1

Outline of hardware copy operation

• Set the hard copy function in "Hard Copy" in "Common Setting" in the SWoD5C-GOTRE-
PACK (o = 2 or larger, Ver. A).
• User screens (which are displayed in the screen mode) only can be output to a printer. Sys-
tem screens (which are displayed in the HPP , alarm, sampling and other modes) cannot be
output to a printer.
• Output to a printer can be started/aborted by setting to ON/OFF a corresponding bit device
in the PC or by pressing a corresponding touch switch.
F940GOT
Key code: FF17
• When starting printing, the GOT aborts communication with the PC for approximately 1 sec-
ond while storing the displayed screen image in the internal memory. After that, the GOT
automatically restarts communication.
Start Abort
Key code: FF18
Additional Functions (in Ver. 3.00 or Later) 14
Caution
RS232C
A printer is connected via RS-232C. While
the PC is connected via RS-232C or while a
bar code reader is connected, the screen hard
RS422
copy function is disabled.
Start trigger: Bit device
Abortion trigger: Bit device
Printer
ESC/P J84 with RS-232C
interface
PC
14-11