Sampling Mode; Outline Of Sampling Mode - Mitsubishi F940GOT-SWD-E Operation Manual

Graphic Operation Terminal F940GOT
5.

Sampling Mode

This section describes the sampling mode in which the contents of data registers always
changing are acquired at a constant time interval (in a constant cycle) or in the ON/OFF condi-
tion (trigger) of bit devices.
The acquired data can be displayed in graph or list format.
The acquired data can be printed in the other mode of the GOT or using the user screen cre-
ation software. The sampling mode can be used to manage the data on the operation rate of
machines and the production status.
5.1

Outline of sampling mode

The contents of the specified 4 data registers (16 bits) are acquired in a constant cycle or by
the trigger condition. The data in up to 2,000 registers can be acquired in a constant cycle, and
the data in up to 2,000 registers can be acquired by the trigger condition.
u u u u Basic operation
SELECT MODE
screen
Paragraph 2.3
[ SAMPLING MODE ]
SET CONDITION
DISPLAY LIST
DISPLAY GRAPH
CLEAR DATA
SAMPLING MODE
Select "SAMPLING
MODE" on the screen.
• When "SAMPLING MODE" is selected, the screen
END
shown on the left is displayed. On this screen, the
a)
sampling condition can be set, the results displayed,
b)
and the acquired data cleared.
c)
d)
a) SET CONDITION (Paragraph 5.2)
Data registers to be sampled, the sampling timing
(trigger or constant cycle), the sampling start time and
the sampling end time can be set.
b) DISPLAY LIST (Paragraph 5.3)
The sampling time (hour, minute and second) and the
sampling result are displayed in the form of list.
c) DISPLAY GRAPH (Paragraph 5.3)
The sampling result is displayed in the form of trend
graph.
d) CLEAR DATA (Paragraph 5.4)
All of the data acquired by sampling is cleared.
SAMPLING MODE
screen
The screen shown
below is displayed.
Sampling Mode 5
5-1