Changing Operands, Set Values - Mitsubishi GT11 User Manual

14.4.10 Changing operands, set values

Changes the operand section of an applied instruction and OUT (T, C) command set value.
1 Operation
Stop the FX PLC
*1 For decimal numbers, input K, then the number.
For hexadecimal numbers, input H, then the number.
2 Example
Changing "MOV D0 D10" to "MOV D0 D123".
Stop the FX PLC
MODE
Move the cursor to the changed
location with
MODE SP
(Read mode)
Moving the cursor to the line on which the operand or set value is to be changed
When starting to change an operand or a set value, place the cursor on the line of
the operand or set value to be changed (the line on which the step number is not
displayed).
If you place the cursor on the command line, the input operation is not possible.
2 LDI M 100
3 MOV 12
D 0
D 10
< READ >
Set the
WRITE
< WRITE >
mode.
or
Input the device name and device number
Command line (Cannot
operate on this line.)
Operand, set value line
(Place the cursor on this line.)
3 MOV
D 0
D 10
8 LD M 10
SP D 1
3 MOV
D 0
D 123
8 LD M 10
14.4 MELSEC-FX List Editor
14.4.10 Changing operands, set values
GO
12
2 3 GO
12
14 - 105
9
10
11
12
13
14
15
16