Parameter - Mitsubishi F940GOT-SWD-E Operation Manual

Graphic Operation Terminal F940GOT
4.3

PARAMETER

u u u u Basic operation
The HPP
MODE screen
is displayed.
SCREEN
[ PARAMETER ]
MEMORY
FILE REG.
LATCH
RANGE
i)
SET
5 6
0 1
n n n n Important point
1) In setting of the memory capacity, the allowable setting range varies depending on the
memory of the connected PLC main body (automatic recognition).
2) In setting of the file register, the allowable setting range of the number of blocks varies
depending on the selected memory capacity.
(One block occupies 500 steps. Up to 14 blocks are allowed when the memory capacity is
set to 16 K steps.)
3) In setting of the latch range, the allowable setting range of device No. varies depending on
the connected PLC main body.
4) Change of each parameter is executed when the END key is pressed.
5) Change of each parameter is enabled only while the PLC main body is stopped.
6) Change of each parameter is enabled only while a RAM or EEPROM (whose write-protect
switch is set to OFF) is used as the memory in the PLC main body.
7) After entering a numeric, press the CLR key to cancel the entered numeric.
Setting of
memory capacity
PARAMETER
Select
"PARAMETER"
on the screen.
Setting of
file register
Setting of
latch range
Initialization
Cancel of
change
a) b)
<WRITE> END
16K CANCEL
SET 0 BLOCK INIT
M500-M1023 S500-S 999
C100-C 199 C200-C 255
(16BIT) 32BIT
D200- D511
7 8 9 CLR
2 3 4 ENT
h) g)
8K
Select the memory
capacity.
a)
Numeric
SET
input
b)
Enter the number
of blocks.
/
SET
Select a
i)
device.
g)
INIT
Return the parameters
to the initial values.
d)
CANCEL
Return a parameter
to a value before
change.
c)
• This function is valid only in the FX Series.
d)
e)
f)
END
Execute
write of
parameters.
Numeric
ENT
input
Register
Enter a
the
device No.
numeric.
h)
f)
HPP Mode 4
4-11