Getting Service - Arris Xfinity TG1682 User Manual

Getting
Safety Started
Ethernet Cable
Battery
Installation Installation
•
•

Getting Service

Before trying to use your new Telephony Gateway, contact your local cable company
to establish an Internet account and telephone service. When you call, have the
fol lowing information ready:
•
•
If the Telephony Gateway was provided by your cable company, they already have
the required information.
In addition, you should ask your cable company the following questions:
•
•
•
•
•
Xfinity TG1682 Telephony Gateway User's Guide
Ethernet
Configuration Usage
Note: A splitter effectively cuts the signal in half and sends each half to its
two outputs. Using several splitters in a line may deteriorate the quality of
your television, telephone, and/or internet connection.
Ethernet Cable(s): as shown in the image to the left, this is a Category 5e
(CAT5e) straight-through cable for connecting computers to the Gateway.
Information packet: your cable company should furnish you with a packet
containing information about your service and how to set it up. Read this in-
formation carefully. Contact your cable company if you have any ques tions.
the Telephony Gateway serial number and cable MAC addresses of the unit
(printed on the back panel of the Telephony Gateway)
the model number of the Telephony Gateway (printed on the bottom panel
of the Telephony Gateway)
Do you have any special system requirements or files that I need to down-
load after I am connected?
When can I start using my Telephony Gateway?
Do I need a user ID or password to access the Internet or my e-mail?
Will my phone number(s) change?
What new calling features will I have and how do I use them?
Troubleshooting Glossary
8