Table of Contents
Advertisement
7.4 EAP200 with Tunnel Management
When an EAP200 is discovered or added to the AP list, it can be logically deployed into the Controller's managed
network regardless of its physical location by tunnels.
Initially when an AP has been successfully added to the List, it's "Tunnel Status" will show a red light indicating that
no tunnel is established and that this AP is only being monitored via SNMP.
If you wish to create a tunnel between this AP and the controller, click the "Edit" button to proceed with necessary
configurations.
In the AP's tunnel configuration page, check "Enable", set a numerical authentications key (0 ~ 4294967295)
between controller and AP. Click Apply to create tunnel.
A new window will automatically open and display the tunnel settings on the AP side which is passed from the
Controller. Click the "Reboot" link to apply and activate the settings.
Once the AP has completed the reboot process, the tunnel will be in effect as shown in the APs "Status >>
Overview" page.
107
Advertisement
Table of Contents
