Table of Contents
Advertisement
5.2.2 Configure Service Zone network
To configure Service Zone, go to: System >> Service Zones.
Service Zone Status: Each service zone can be enabled or disabled except for the default service zone.
Service Zone Name: The name of service zone could be input here.
Network Interface:
VLAN Tag: The VLAN tag number that is mapped to the Service Zone.
o
Operation Mode: Contains NAT mode and Router mode. When NAT mode is chosen,
o
the service zone runs in NAT mode. When Router mode is chosen this service zone runs in Router
mode.
IP Address: The IP Address of this service zone.
o
Subnet Mask: The subnet Mask of this service zone.
o
IPv6 Settings: The IPv6 Address and configuration of this service zone (When IPv6 enabled).
o
Network Alias List: Administrator may optionally set many alias network segments for a service
o
zone. This feature can allow a single service zone to be seen as many service zones, also hide the
IP address of a Service Zone's network interface and to some degree, provide protection from
possible attacks from LAN clients.
Click the Configure button to enter the Network Alias List page.
Fill in the desired alias IP address and select the preferred Subnet Mask, Operation mode,
36
Advertisement
Table of Contents
