Table of Contents
Advertisement
2.4 Hardware Description
5.2.2 Front Panel
1.
LED Indicators: There are three kinds of LED, Power, Status and Hard-disk, to indicate different status of
the system.
2.
Mgmt: For management use only, it always will open WMI (Web Management Interface) homepage.
connect to this port with PC directly, please use crossover Ethernet cable.
3.
WAN1/ WAN2: Two WAN ports (10/100/1000 Base-T RJ-45) are connected to the external network, such as
the ADSL Router from your ISP (Internet Service Provider).
4.
LAN1/ LAN2: Client machines connect to WHG-505 via these LAN ports (10/100/1000 Base-T RJ-45).
5.
Reset:
Press and hold the Reset button for about 5 seconds and status of LED on front panel will start to blink
before restarting the system.
Press and hold the Reset button for more than 10 seconds and status of LED on the front panel will start
to speed up blinking before resetting the system to default configuration.
6.
Console: The system can be configured via a serial console port. The administrator can use a terminal
emulation program such as Microsoft's Hyper Terminal to login to the configuration console interface to change
admin password or monitor system status, etc.
By default, all LAN ports are set with Port-based Default Service Zone; for Service Zone
Note:
configuration, please refer to 3. 5 LAN Partition – Service Zone.
7
If
Advertisement
Table of Contents
