Mitsubishi Lancer Evolution-VII Workshop Manual page 1108

26-8
245±29 N·m
MB990767
MB991000
(MB990998)
MB991017
245±29 N·m
Secure bolt and
tighten nut.
MB990685
MB991000
(MB990998)
245±29 N·m
Secure bolt and
tighten nut.
MB991017
FRONT AXLE -
Hub and Knuckle Assembly
INSTALLATION SERVICE POINT
Washer
"AACASTLE NUT INSTALLATION
1. Be sure to install the castle nut washer in the specified
2. Using the special tool, tighten the castle nut.
INSPECTION
INSPECTION OF WHELL BEARING ROTATION STARTING
TORQUE
1. Tighten special tools in hub and knuckle assembly to
Bolt
2. Measure the wheel bearing rotation starting torque with
3. Wheel bearing rotation starting torque must be under
MB990326
WHEEL BEARING AXLE PLAY CHECK
1. Secure knuckle in a vice to measure axle play in wheel
2. If the limit value of wheel bearing axle plya cannot be
direction.
Caution
Before securely tightening the castle nuts, make sure
there is no load on the wheel bearings. Otherwise
wheel bearing will be damaged.
the specified torque.
special tools.
Limit: 1.03 N·m or less
the limit value and there should be no roughness when
rotating the hub.
bearing.
Limit: 0.06 mm
obtained when tightened to the specified torque (245
± 29 N·m), check mounting bolt for hub and knuckle
assembly. If no defects are found, replace hub assembly.