Mitsubishi Lancer Evolution-VII Workshop Manual page 1227

REAR SUSPENSION -
Mating marks
MB991406,
MB990635 or
MB991113
Ball joint
Nut
Mating marks
with red marking: RH side lower arm
assemblly
with countersunk ø10 mm: LH side lower arm
assemblly
MB990968
Lower Arm Assembly/Toe Control Arm Assembly
REMOVAL SERVICE POINTS
AA" LOWER ARM ASSEMBLY MOUNTING BOLT
Mark the mating marks on the lower arm and the decentering
cam bolt,then remove the lower arm and the decentering cam
bolt.
AB" TOE CONTROL ARM ASSEMBLY AND KNUCKLE
Caution
1. To prevent the ball joint thread from damage, only
Cord
2. The special tool should be suspended from a cord
AC" TOE CONTROL ARM ASSEMBLY MOUNTING
Mark the mating mark on the toe control arm and the
decentering cam bolt,then remove the toe control arm and the
decentering cam bolt.
Decentering
cam bolt
INSTALLATION SERVICE POINTS
"AA LOWER ARM ASSEMBLY INSTALLATION
Check the identification mark, install the lower arm assembly.
INSPECTION
TOE CONTROL ARM BALL JOINT ROTATION TORQUE
MB990326
CHECK
1. After shaking the toe control arm ball joint stud several
2. When the measured value exceeds the standard value,
REMOVAL
DISCONNECTION
loosen but do not remove the nut securing the upper
arm to the knuckle from the ball joint and use the
special tool.
to prevent it from being dropped.
BOLT REMOVAL
times, use the special tool to measure the rotation torque
of the toe control arm ball joint.
Standard value: 0.5 - 2.5 N·m
replace the toe control arm assembly.
34-13