On-Vehicle Service; Speedometer Check - Mitsubishi Lancer Evolution-VII Workshop Manual

Inspection procedure 5
All meters inoperative
When individual indicators and warning lamps are properly operated, harness
from power source (IG1) to combination meter is normal.
Check the following connectors:
<L.H. drive vehicles> C-01, C-29, C-213
<L.H. drive vehicles> C-01, C-213
Check harness from ignition switch (IG1) to combination meter.
Check the following connectors: C-01
Check harness from combination meter to body earth.
Check trouble symptom.
NG
Replace meter assembly.
Extension
fitting
Front
Anchor plate
CHASSIS ELECTRICAL - CHASSIS ELECTRICAL -
OK
OK
OK
OK

ON-VEHICLE SERVICE

SPEEDOMETER CHECK

(1) Ensure that tire pressure indicates the value of tire
(2) Place the vehicle on speedometer tester.
(3)
(4) For prevention of front wheel lateral runout, install
(5) For prevention of vehicle from starting out, install chain
(6) Ensure that speedometer indication range is within
Combination Meter Combination Meter
Probable cause
D Meter assembly fault
D Harness or connector fault
NG
Repair
NG
Repair
NG
Repair
NG
Repair
pressure label.
Set the free rollers securely under rear wheels.
extension fittings on front towing eye and tie down hook,
and install both ends on anchor plate.
or wire (the other end of which is tightly fixed on rear
towing eye) on the vehicle.
standard value, or pointer deflection is within limit value.
Caution
During operation, avoid excessive acceleration and
deceleration.
Standard value:
Vehicle speed km/h 40
Indication range of 37 - 45
speedometer km/h
Limit:
Pointer deflection
(vehicle speed: 35 km/h or more): ±3 km/h
54A-19
80 120 160
75 - 88 113 - 150
132 176
-