Mitsubishi Lancer Evolution-VII Workshop Manual page 1197

Wooden block
Transmission jack
Cord
Ball joint
Nut
Wooden
block
Outside of
vehicle
Bushing
POWER PLANT MOUNT - Crossmember
REMOVAL SERVICE POINTS
AA" LOWER ARM ASSEMBLY REMOVAL
Lift the transmission with a transmission jack, and then
withdraw the front mounting bolt on the left lower arm
assembly.
Mounting bolt
AB"TIE ROD END AND KNUCKLE DISCONNECTION
Caution
1. The thread on the ball joint may be damaged. Do
MB990635
2. Suspend the special tool with a cord to prevent it
MB991113 or
MB991406
AC" CROSSMEMBER ASSEMBLY REMOVAL
Retain the crossmember with a transmission jack, and then
remove the crossmember mounting bolt.
Transmission
jack
INSTALLATION SERVICE POINT
"AASTABILIZER BAR INSTALLATION
Identification
colour
Align the identification colour on the left side of the stabilizer
bar with the right end of the bushing.
Fixture
INSPECTION
D
not remove the tie rod end mounting nut from the
ball joint. Just loosen the nut. For this operation, use
the special tool.
from dropping.
Check the crossmember for cracks and damage.
32-11