Mitsubishi Lancer Evolution-VII Workshop Manual page 702

12-6
ENGINE LUBRICATION -
4. Install the oil pressure gauge.
5. Run the engine to warm it.
6. After the engine has been warmed up, check that oil
7. Remove the oil pressure gauge.
8. Apply the specified sealant to the thread of oil pressure
9. Use the special tool to tighten the oil pressure switch
MD998054
10. Install the oil pressure switch terminal.
On-vehicle Service
NOTE
Use a adapter of PT 1/8 thread.
pressure is within the standard value.
Standard value:
At idle: 29 kPa or more
At 3,500 r/min: 294 - 686 kPa
switch.
Specified sealant: 3M ATD Part No. 8660 or equivalent
to the specified torque.
Tightening torque: 10 ± 2 N·m
Caution
Do not start the engine within one hour after the oil
pressure switch has been installed.