Mitsubishi Lancer Evolution-VII Workshop Manual page 691

ENGINE OVERHAUL -
Groove
No. 3
No. 2
No. 1
No. 5
Timing belt side
Cylinder block bearing section
bore identification mark
No. 4
No. 3
No. 1 No. 2
Crankshaft and Cylinder Block
INSTALLATION SERVICE POINTS
"AA THRUST BEARING INSTALLATION
1. Install the thrust bearing onto the cylinder block side of
the No. 3 bearing section. The bearing can be installed
easily by applying engine oil.
2. Install the thrust bearing so that the side with the groove
faces the crankshaft weight side.
"BA CRANKSHAFT BEARING INSTALLATION
1. Measure the diameter of the crankshaft journal, and
confirm the class shown below. When using a spare part,
each identification colour is painted at the position shown
in the illustration.
No. 4
2. The cylinder block bearing section bore identification mark
is stamped at the position shown in the illustration.
Crankshaft journal
Class Product
identifica-
No. 5
tion colour
1 None
Cylinder
bore size
mark
2 None
3 None
Cylinder
block
bearing bearing
Spare part Journal
section
identifica- diameter
bore iden-
tion colour mm
tification
mark
Yellow 56.994 - 0
57.000 57 000
1
2
None 56.988 - 0
56 994 56.994
1
2
White 56.982 - 0
56 988 56.988
1
2
11B-65
Spare
bearing
identifica- identifica
tion mark
0
1
2
1
2
3
2
3
4