Mitsubishi Lancer Evolution-VII Workshop Manual page 1087

MANUAL TRANSMISSION OVERHAUL -
MD998917 MB990932
MD998823
Differential case
Lock pin
Pinion shaft
AB" TAPER ROLLER BEARING REMOVAL
Using the special tool, remove the taper roller bearing from
the center differential case.
REASSEMBLY SERVICE POINTS
"AA TAPER ROLLER BEARING INSTALLATION
MB990937
Using the special tool, install the taper roller bearing onto
the center differential case.
"BA TAPER ROLLER BEARING INSTALLATION
Using the special tool, install the taper roller bearing onto
MD998812
the center differential flange.
"CA SPACER/SIDE GEAR/WASHER/PINION/PINION
(1) After assembling the spacer onto the side gear, install
the side gear into the center differential case.
NOTE
When installing a new side gear, assemble a medium
thickness (0.8 or 0.9 mm) spacer.
(2) Align the washer on the back of the pinion. Engage the
four pieces onto the side gear simultaneously, and rotate
to install at the specified position. Then, install the pinion
shaft holder.
(3) Insert the pinion shaft into the differential case.
(4) Install the lock pin in the direction shown in the illustration.
Center Differential
SHAFT HOLDER/PINION SHAFT/LOCK
PIN/FRONT OUTPUT SHAFT/SNAP RING/CENTER
DIFFERENTIAL FLANGE INSTALLATION
22B-49