Engine Assembly - Mitsubishi Lancer Evolution-VII Workshop Manual

ENGINE ASSEMBLY

REMOVAL AND INSTALLATION
Caution
1. If the vehicle is equipped with the Brembo disc brake, during maintenance, take care not to
contact the parts or tools to the caliper because the paint of caliper will be scratched.
2. Tightening sections indicated in the mark (*) should be finally tightened with engine weight
applied on the body after lightly tightening.
Pre-removal and Post-installation Operation
Fuel Outflow Preventive Operation (Refer to GROUP 13A - On-vehicle Service.) <Before removal only>
D
Fuel Leak Check <After installation only>
D
Removal and Installation of Hood (Refer to GROUP 42.)
D
Removal and Installation of Strut Tower Bar (Refer to GROUP 42.)
D
Removal and Installation of Under Cover (Refer to GROUP 51 - Front Bumper.)
D
Removal and Installation of Side Cover.
D
Drive Belt Tension Check (Refer to P.11A - 7.) <After installation only>
D
Accelerator Cable Adjustment (Refer to GROUP 17 - On-vehicle Service.) <After installation only>
D
Drainage and Refilling Engine Oil(Refer to GROUP 12 - On-vehicle Service.)
D
Drainage and Refilling of Engine Coolant (Refer to
D
Air Cleaner Removal and Installation (Refer to GROUP 15)
D
Removal and Installation of Air Pipe C, Air Pipe B and Air Hose A (Refer to GROUP 15 - Intercooler.)
D
Battery and Battery Tray Removal and Installation
D
Removal and Installation of Center Cover (Refer to P.11A - 17.)
D
Removal and Installation of Accelerator Cable (Refer to GROUP 17.)
D
Removal and Installation of Radiator (Refer to GROUP 14.)
D
Removal and Installation of Crossmember Bar (Refer to GROUP 32 - Engine Roll Stopper, Centermember.)
D
Removal and Installation of Front Exhaust Pipe (Refer to GROUP 15.)
D
Removal and Installation of Air Outlet Fitting (Refer to GROUP 15 - Exhaust manifold.)
D
ENGINE -
Engine Assembly
GROUP 14 - On-vehicle Service.)
11A-43