Mitsubishi Lancer Evolution-VII Workshop Manual page 1282

Hide thumbs Also See for Lancer Evolution-VII:
Table of Contents

Advertisement

35B-18
Inspection Procedure 3
When the ignition key is turned to "ON" (engine stopped),
the ABS warning lamp does not illuminate.
The cause may be an open circuit in the lamp power supply circuit, a blown lamp,
or an open circuit between the ABS warning lamp and the earth.
Does the ABS warning lamp illuminate when the ABS-ECU
connector B-123 is disconnected and the ignition switch is turned
to ON?
Check whether the ABS warning lamp bulb is burnt out.
Check the following connectors:
B-123, C-01, C-29 <L.H. drive vehicles>, C-128, C-210, C-213
Check the harness wire.
D Between combination meter and ABS-ECU
D Between ignition switch (IG1) and combination meter
D Between combination meter and earth
Replace the combination meter. (Refer to GROUP 54A.)
Inspection Procedure 4
Even after the engine is started, the ABS warning lamp
remains illuminated.
The cause is probably a short-circuit in the ABS warning lamp illumination circuit.
NOTE
This trouble symptom is limited to cases where communication with the MUT-II is possible (ABS-ECU
power supply is normal) and the diagnosis code is a normal diagnosis code.
Does the ABS warning lamp stay illuminated when the ABS-ECU
connector B-123 is disconnected and the ignition switch is turned
to ON?
Check the following connectors: B-123, C-01, C-128
Check the trouble symptom.
Check the harness wire.
D Between combination meter and ABS-ECU
Replace the combination meter. (Refer to GROUP 54A.)
ABS <4WD> -
NO
OK
OK
OK
YES
OK
NG
OK
Troubleshooting
Probable cause
D Blown fuse
D Burn out ABS warning lamp bulb
D Malfunction of combination meter
D Malfunction of wiring harness or connector
D Malfunction of hydraulic unit and ABS-ECU
YES
Replace the hydraulic unit and ABS-ECU.
NG
Replace the ABS warning lamp bulb.
NG
Repair
NG
Repair
Probable cause
D Malfunction of combination meter
D Malfunction of wiring harness (short circuit)
D Malfunction of hydraulic unit and ABS-ECU
NO
Replace the hydraulic unit and ABS-ECU.
NG
Repair
NG
Repair

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents