Configuring the PSTN (FXO) Gateway on the SPA3102
Call Scenarios
Call Scenarios
Cisco Small Business ATA Administration Guide
Call Progress Tones (SPA3102 and SPA8800)
The SPA3102 and the SPA8800 have configurable call progress tones. Call
progress tones are generated locally on the ATA, so an end user is advised of
status (such as ringback). Parameters for each type of tone (for instance a dial tone
played back to an end user) may include the following specifications:
Number of frequency components
Frequency and amplitude of each component
Cadence information
When one VoIP account is shared between the FXS and PSTN Lines, the following
parameters are recommended to be set. For more information, see the Regional
page in the
ATA Voice Field Reference, on page
Call Progress Tone
VoIP PIN Tone
PSTN PIN Tone
Outside Dial Tone
This section describes some typical scenarios where the ATA device can be
applied. Some terms are introduced in the first few sections and reused in later
sections. This section includes the following topics:
PSTN to VoIP Call with and Without Ring-Thru section on page 96
VoIP to PSTN Call With and Without Authentication section on page 96
Call Forwarding to PSTN Gateway (SPA3102 and SPA8800) section on
page 98
Description
This tone is played to prompt a VoIP caller to enter a PIN number.
This tone is played to prompt a PSTN caller to enter a PIN
number.
During two-stage PSTN-gateway dialing and with a dial plan
assigned, the ATA device collects digits from the VoIP caller and
processes the number using the dial plan. The ATA device plays
the
to prompt the VoIP caller to enter the
PSTN number. This tone should be specified to sound different
from the PSTN dial tone.
110.
6
95