ATA Voice Field Reference
PSTN Line page (SPA3102)
Cisco Small Business ATA Administration Guide
FAX Enable T38
FAX Tone Detect
Mode
Symmetric RTP
Dial Plans section
Dial Plan 1/2/3/4/5/
6/7/8
To enable the use of the ITU-T T.38 standard for faxing,
select yes. Otherwise, select no.
The default is yes.
This parameter has three possible values:
caller or callee - SPA will detect FAX tone whether it is
callee or caller
caller only - SPA will detect FAX tone only if it is the caller
callee only - SPA will detect FAX tone only if it is the callee
The default is caller or callee.
(SPA3102 and SPA8800 only) Enable symmetric RTP
operation. If enabled, the ATA sends RTP packets to the
source address and port of the last received valid inbound
RTP packet. If disabled (or before the first RTP packet
arrives) the ATA sends RTP to the destination as indicated
in the inbound SDP.
The default is yes.
Dial plan script for this line.
The default is (xx.) Dial plans in the dial plan pool to be
associated with a VoIP Caller or a PSTN Caller. Each dial
plan in the pool is referenced by a index 1 to 8
corresponding to Dial Plan 1 to 8. The dial plan syntax is the
same as that used for Line 1. See
page
175.
B
Dial Plan section, on
205