Cisco SPA2102 Administration Manual page 148

ATA Voice Field Reference
Regional page
Cisco Small Business ATA Administration Guide
Feature Dial
Services Codes
These codes tell the ATA device what to do when the user
is listening to the first or second dial tone.
One or more *code can be configured into this parameter,
such as *72, or *72| * 74|*67|*82, etc. Max total length is 79
chars. This parameter applies when the user has a dial tone
(first or second dial tone). Enter *code (and the following
target number according to current dial plan) entered at the
dial tone triggers the ATA device to call the target number
prepended by the *code. For example, after user dials *72,
the ATA device plays a special tone called a Prompt tone
while awaiting the user to enter a valid target number.
When a complete number is entered, the ATA device sends
a INVITE to *72
feature allows the proxy to process features like call
forward (*72) or BLock Caller ID (*67).
The *codes should not conflict with any of the other vertical
service codes internally processed by the ATA device. You
can empty the corresponding *code that you do not want
to ATA device to process.
You can add a parameter to each *code in Features Dial
Services Codes to indicate what tone to play after the
*code is entered, such as *72‘c‘| * 67‘p‘. Below are a list of
allowed tone parameters (note the use of back quotes
surrounding the parameter w/o spaces)
‘c‘ = <Cfwd Dial Tone>
‘d‘ = <Dial Tone>
‘m‘ = <MWI Dial Tone>
‘o‘ = <Outside Dial Tone>
‘p‘ = <Prompt Dial Tone>
‘s‘ = <Second Dial Tone>
‘x‘ = No tones are place, x is any digit not used above
If no tone parameter is specified, the ATA device plays
Prompt tone by default.
If the *code is not to be followed by a phone number, such
as *73 to cancel call forwarding, do not include it in this
parameter. In that case, simple add that *code in the dial
plan and the ATA device send INVITE *73@..... as usual
when user dials *73.
as in a normal call. This
B
148