Cisco SPA2102 Administration Manual page 176

ATA Voice Field Reference
Line page
Cisco Small Business ATA Administration Guide
Dial Plan
Enable IP Dialing
Dial plan script for this line.
The default is (*xx|[3469]11|0|00|[2-9]xxxxxx|1xxx[2-
9]xxxxxxS0|xxxxxxxxxxxx.)
The dial plan syntax is expanded in the SPA3102 to allow
the designation of three parameters to be used with a
specific gateway:
•
uid – the authentication user-id
•
pwd – the authentication password
•
nat – if this parameter is present, use NAT mapping
Each parameter is separated by a semi-colon (;).
Furthermore, it recognizes gw0, gw1, …, gw4 as the locally
configured gateways, where gw0 represents the local
PSTN gateway in the same SPA3102.
Example 1:
Example 2:
Example 3:
Enable or disable IP dialing.
If IP dialing is enabled, one can dial [user-id@]a.b.c.d[:port],
where ‘@’, ‘.’, and ‘:’ are dialed by entering *, user-id must be
numeric (like a phone number) and a, b, c, d must be
between 0 and 255, and port must be larger than 255. If
port is not given, 5060 is used. Port and User-Id are
optional. If the user-id portion matches a pattern in the dial
plan, then it is interpreted as a regular phone number
according to the dial plan. The INVITE message, however, is
still sent to the outbound proxy if it is enabled.
The default is no.
B
176