Subscriber Information Section - Cisco SPA2102 Administration Manual

ATA Voice Field Reference
PSTN Line page (SPA3102)
Cisco Small Business ATA Administration Guide
Proxy Fallback Intvl This parameter sets the delay (sec) after which the PAP2T
Proxy Redundancy
Method

Subscriber Information section

Display Name
User ID
Password
Use Auth ID
Auth ID
Call Capacity
will retry from the highest priority proxy (or outbound
proxy) servers after it has failed over to a lower priority
server. This parameter is useful only if the primary and
backup proxy server list is provided to the PAP2T via DNS
SRV record lookup on the server name. (Using multiple
DNS A record per server name does not allow the notion of
priority and so all hosts will be considered at the same
priority and the PAP2T will not attempt to fall back after a
fail over).
The default is 3600
The PAP2T makes an internal list of proxies returned in
DNS SRV records. In normal mode this list will contain
proxies ranked by weight and priority.
If the parameter
PAP2T creates a list in normal mode first, and then inspects
the port numbers based on the 1
The default is Normal.
Display name for caller ID.
Extension number for this line.
Password for this line.
To use the authentication ID and password for SIP
authentication, select yes. Otherwise, select no to use the
user ID and password.
The default is no.
Authentication ID for SIP authentication.
Maximum number of calls allowed on this line interface.
Choices: {unlimited,1,2,3,…25 }. Default is 16. Note that the
ATA device does not distinguish between incoming and
outgoing calls when talking about call capacity.
NOTE: unlimited = 16
B
is configured, the
st proxy’s port on the list.
201