Table of Contents
Advertisement
Operations
Date/Time <Configure>
Sets the date and time of the unit.
≥ The settings are used for the date display on the control panel or the Web interface, in the event of an error or
warning, and for recording the internal logging date or magazine detail information.
≥ The writing or access date for files or folders to be wrote in the magazine is set by the server file system.
≥ Change the settings, then select "Submit" to accept the change.
Enable Time Server
Time Server Address
Date/Time
Time Zone/DST <Configure>
Sets time zone and daylight saving time.
≥ Change the settings, then select "Submit" to accept the change.
Time Zone
DST
Web interface operation
Sets the use or non-use of a timeserver.
Check (enable): Enables a timeserver to synchronize the time. The
synchronization interval is 256 seconds.
Uncheck (disable): Disables a timeserver.
≥ This function is disabled in the initial setting.
Inputs a time server address.
≥ Inputs an IPv4 address, IPv6 address, or fully qualified domain name (FQDN, a
maximum of 256 characters).
Sets the date and time.
≥ The setting can be made when "Enable Time Server" has been disabled.
Sets the time zone.
≥ The date and time are set according to the time zone setting.
≥ The initial setting is "GMT+09:00".
Sets the use or non-use of Daylight Saving Time.
≥ The Daylight Saving Time setting is not programmed to start and end
automatically. Switch the setting for each time change of each area.
On: Sets the time 1 hour forward.
Off: Uses the regular time setting.
≥ The initial setting is "Off".
87
Advertisement
Table of Contents
