Panasonic LB-DH8 series Operator's Manual page 131

Others
Email
Code
notification
E2020
E2021
±
E2022
E2023
E2030
E2031
E2032 ±
E2033
E2034
E3000
±
E3010
±
E3011
E3012
±
E3013
±
E3020
±
E3030
±
Errors and warnings
SNMP trap
notification
The changer mechanism in the changer unit or the drive in the drive
system has failed to operate.
)Withdraw the magazine drawer to make sure the installation of
±
magazine is correct.
)Turn the unit off and back on and retry the operation.
If it still does not operate, it needs to be repaired.
Failed to communicate between modules configured in the unit, or
with the changer unit or the barcode reader in the unit
)Check the connection of the USB cables to the modules. Turn off
± and on the unit, and try again.
If communication failure still persists, a repair is needed.
An error has been detected in the drive in the drive system or the
±
peripheral circuit of the drive.
It needs to be repaired.
A fault has been detected in several of the drives of the drive
system. There is an abnormality of the media in the magazine or a
failure of the drive or peripheral circuits of the drive.
±
)Try another magazine. If the system detects the same error, it
needs to be repaired.
)For information on the conditions that cause the error, refer to
"RAID functions" ( 103).
Cannot write and read since the temperature of drive system is too
high.
)Check if an exhaust port of the fan at the rear of the main unit is
being clogged with an obstacle, and if yes, remove the obstacle.
±
)Check the log records to determine if the regular fan or redundant
fan has a fault, and if yes, it needs to be repaired.
If the problem persists, please contact your support service
provider. ( 138)
A magazine data error has been found.
±
)Replace the magazine in question with a good one.
Magazine formatting has failed.
)Check the log records to determine if the drive system or
±
magazine has a defect, and if yes, take proper action in
accordance with the error or warning code corresponding to the
detected defect.
Failed write operation of two or more drives in the drive system.
There is an abnormality in the media in the magazine or a failure of
the drive or peripheral circuits of the drive.
±
)Try another magazine. If the system detects the same error, it
needs to be repaired.
)For information on the conditions that cause the error, refer to
"RAID functions" ( 103).
131
Action to be taken