Table of Contents
Advertisement
Others
Email
Code
notification
W2140
s
W2150
s
W3000
±
W3010
±
W3011
±
W3020
±
W3030
±
W3040
±
W3050
s
Errors and warnings
SNMP trap
notification
The changer unit is operating.
s
)Check the changer status by control panel or Web interface and
retry processing after the status changes to "Ready".
The specified processing cannot be performed because of the
magazine eject mode set for taking out a disc specified by an
s
application.
)Turn off the magazine eject mode on the application, and try
again.
Detected that the life of the drive system is nearly at its end.
±
)Replacing the drive system or peripheral circuit is recommended.
The redundancy of writing has decreased owing to a drive system
fault or a media defect during RAID writing.
±
)Check the log records to determine if there is a drive system or
magazine defect, and if yes, take proper action in accordance
with the error or warning code corresponding to the defect.
When reading RAID, the read redundancy is low due to a failure of
the drive system or media.
±
)Check the log records to determine if there is a drive system or
magazine defect, and if yes, take proper action in accordance
with the error or warning code corresponding to the defect.
A fault has been detected in several of the drives of the drive
system. The redundancy at RAID writing or RAID reading
±
decreases. To recover the redundancy, repair the drives.
)For information on the conditions that cause the warning, refer to
"RAID functions" ( 103).
One or more drives or discs in the drive system have failed to
startup. Redundancy during RAID writing or RAID reading is
±
reduced. Repairs might be required for recovery.
)For information on the conditions that cause the warning, refer to
"RAID functions" ( 103).
Writing to the magazine is not possible because the magazine
±
management information area has run out.
)Take a copy to another magazine.
The RAID level cannot be set from the control panel or the Web
s
interface because it has been set from an application.
136
Action to be taken
Advertisement
Table of Contents
