Panasonic LB-DH8 series Operator's Manual page 134

Others
Email
Code
notification
W1082
s
W1083
s
W1084
s
W1085
s
W1100
s
W1101
s
W1102
s
W1103
s
W1104
s
W1105
s
W1110
s
W1111
s
W1112
s
W1120
s
W1121
s
Errors and warnings
SNMP trap
notification
The password you entered does not meet the password rules.
s
)Include alphabets in the password.
The password you entered does not meet the password rules.
s
)Include symbols in the password.
The initial password has not been changed.
s
)Change the password.
Login is disabled due to an invalid password.
s
)Login will be enabled 3 minutes later. Please try again.
The unit cannot be turned off due to an error in the changer unit.
s
)To force the unit to turn off, select "Yes".
The unit cannot be turned off because the changer mechanism has
s failed to move to a set position.
)To force the unit to turn off, select "Yes".
The command for turning off the unit was set while the unit was
s
processing the previous command for turning itself off.
)Wait until the unit turns off.
The unit cannot be turned off because the software is being
s
updated.
)Try again after the update is complete.
The unit cannot be turned off because the magazine eject mode is
set.
s
)Turn off the magazine eject mode on the application, and try
again.
The unit cannot be turned off because the application prohibits the
s ejection of the media from the drive system.
)Permit ejection from the application and try again.
The software cannot be updated because the changer unit is in an
s
error state.
)To continue the software update, select "Yes".
The software cannot be updated because the changer mechanism
s has failed to move to a set position.
)To continue the software update, select "Yes".
The command for a software update was set while software was
s
being updated.
Self-diagnostics is re-specified during self-diagnostics.
s
)Wait for the self-diagnostics to complete.
Self-diagnostic cannot be executed because a magazine is loaded
s in the drive system.
)Refer to "Diagnostic" ( 109).
134
Action to be taken