Adjusting The Throttle Link And Throttle Cable Operation (Using A Thickness Gauge) - Yamaha F150A Service Manual

10. Contact the stopper 0 on the throttle
lever 2 to the fully closed stopper A on
the cylinder block and check that throttle
cam roller B is aligned with the align-
ment mark c.
B
c
0
A
11. Adjust the position of the throttle cable
joint until its hole is aligned with the set
pin on throttle lever 2.
d
CAUTION:
The throttle cable joint must be screwed
in a minimum of 8.0 mm (0.31 in) d.
12. Connect the cable joint, install the clip,
and then tighten the locknut.
13. Check the throttle cable for smooth oper-
ation and, if necessary, repeat steps 1–
12.
63P3F11
Adjusting the throttle link and
throttle cable operation
(using a thickness gauge)
1. Remove the intake silencer.
2. Loosen the locknut 1, remove the clip
2, and then disconnect the throttle cable
joint 3.
3. Contact the stopper 4 on the throttle
lever 2 to the fully closed stopper 5 on
the cylinder block and adjust the throttle
link rod joint 6 so that the specified
clearance a between the throttle cam
roller and the throttle cam is obtained.
S63P3200
S63P3210
4. Connect the throttle link rod joint 6, and
then tighten the locknut 7.
Control system
a
6
2
4
5
3
Clearance a: 0.5 mm (0.02 in)
7
6
1
2
3
4
5
1
6
S63P3220
7
8
9
S63P3230
3-10