Yamaha F150A Service Manual page 228

BRKT
2
1
Trim sensor setting resistance:
Pink (P) – Black (B)
9–11 Ω at 20 °C (68 °F)
Trim sensor cam screw 1:
2 N·m (0.2 kgf·m, 1.5 ft·lb)
4. Fully tilt the outboard motor up, and then
support it with the tilt stop lever 3.
3
WARNING
After tilting up the outboard motor, be
sure to support it with the tilt stop lever.
Otherwise, the outboard motor could sud-
denly lower if the power trim and tilt unit
should lose fluid pressure.
5. Check the trim sensor resistance. If the
resistance is out of specification, adjust
the trim sensor cam position and check
the trim sensor.
7-19
Bracket unit
B
Gy
P
S60X7160
S60X7170
Trim sensor resistance:
Pink (P) – Black (B)
238.8–378.8 Ω at 20 °C (68 °F)
63P3F11