Assembling The Power Trim And Tilt Motor; Removing The Reservoir - Yamaha F150A Service Manual

BRKT
Assembling the power trim and tilt
motor
1. Connect the PTT motor leads 1, and
then tighten the screws 2.
2. Push the brushes 3 into the brush
holder, and then install the armature 4.
3. Install the stator onto the base.
NOTE:
Place a clean cloth over the end of the arma-
ture shaft, hold it with a pair of pliers, and
then carefully slide the stator over the arma-
ture.
7-33
Bracket unit
1
2
S60X7310

Removing the reservoir

1. Hold the power trim and tilt unit in a vise
using aluminum plates a on both sides.
CAUTION:
Do not use rags or paper to clean the
hydraulic system
pieces of fibers remaining on them can
cause the system to malfunction.
NOTE:
Place a container under the power trim and
tilt unit to catch the fluid.
2. Remove the reservoir and O-rings.
CAUTION:
• Make sure that the trim and tilt rams are
fully extended when removing the reser-
voir, otherwise fluid can spurt out from
the unit due to internal pressure.
• Do not push the tilt and trim rams down
while the power trim and tilt motor is
removed from the power trim and tilt
unit, otherwise fluid can spurt out.
components. Small
S60X7400
63P3F11