Installing The Drive Shaft - Yamaha F150A Service Manual

Needle bearing attachment 1:
90890-06610
Driver rod SS 2: 90890-06604
Bearing depth plate 3: 90890-06603
Depth a:
5.75–6.25 mm (0.226–0.246 in)
2. Apply grease to a new oil seals, and then
install them into the drive shaft housing
to the specified depth.
NOTE:
Install an oil seal halfway into the drive shaft
housing, then the other oil seal.
Ball bearing attachment 4:
90890-06633
Driver rod LS 5: 90890-06606
Depth b:
0.25–0.75 mm (0.010–0.030 in)

Installing the drive shaft

1. Install the forward gear into the lower
case.
63P3F11
Drive shaft and lower case (regular rotation model)
2. Install the drive shaft housing 1, thrust
bearing 2, and original shim(s) 3 onto
the drive shaft 4.
CAUTION:
Add or remove shim(s), if necessary, if
replacing the drive shaft housing or drive
shaft.
3. Install the sleeve, drive shaft and drive
shaft housing into the lower case, then
the pinion and pinion nut, and then
tighten the nut to the specified torque.
NOTE:
Install the drive shaft by lifting it up slightly,
then aligning it with the pinion and the spline
of the drive shaft.
Drive shaft holder 6 5: 90890-06520
Pinion nut holder 6:
New: 90890-06715
Current: 90890-06505
Pinion nut:
93 N·m (9.3 kgf·m, 68.6 ft·lb)
4. Tighten the drive shaft housing bolts.
5
6
S63P6310
6-20
1
2
3
4
5
6
7
8
9