Installing The Power Trim And Tilt Unit - Yamaha F150A Service Manual

Rams PTT motor lead
Sky blue (Sb)
Up
Light green (Lg)
NOTE:
• Repeat this procedure so that the rams go
up and down four or five times (be sure to
wait a few seconds before switching the
leads).
• If the rams do not move up and down eas-
ily, push and pull on the rams to assist
operation.
8. Check the fluid level when the tilt ram is
fully extended. Add sufficient fluid if nec-
essary.

Installing the power trim and tilt unit

1. Fully tilt the outboard motor up, and then
support it with the tilt stop lever 1.
1
63P3F11
CAUTION:
After tilting the outboard motor up, be
sure to support it with the tilt stop lever.
2. Install the collars.
3. Lift the power trim and tilt unit up, and
4. Install the circlip.
Battery
terminal
5. Install the lower mounting shaft, and then
+
-
6. Install the plastic ties, route the PTT
7. Connect the ground lead to the bottom of
S60X7820
Power trim and tilt unit
then install the upper mounting shaft.
tighten the bolts.
motor leads through the hole, and then
install the plastic ties.
the power trim and tilt unit, and then
tighten the bolt.
A A
A A
A A
LT
242
1
2
3
4
5
A A
6
7
A A
S60X7130
8
9
7-44