Adjusting The Throttle Cable - Yamaha 250GETO Service Manual

Adjusting the throttle cable

NOTE:
Before adjusting the throttle cable, the throttle
stop screw should be properly adjusted.
1. Loosen the locknut 1, remove the clip 2
and then remove the throttle cable joint
3.
1
2
3
2. Set the remote control lever to the fully
closed position.
3. Adjust the position of the throttle cable
joint 3 until its hole aligned with the set
pin 4 on control lever.
3
a
6S35H11
6S330320
4
6S330330
6S330390
w
The throttle cable joint must be screwed in
a minimum of 8.0 mm (0.31 in) a.
NOTE:
Pull the throttle cable towards the engine to
remove any free play in the cable before
adjusting the position of the throttle cable
joint.
4. Connect the cable joint 3, install the clip
2, and then tighten the lock nut 1.
1
2
3
Control system
1
2
3
4
6S330320
5
6
7
8
9
3-8