Disassembling The Tilt Cylinder And Trim Cylinder - Yamaha F150A Service Manual

BRKT
Disassembling the tilt cylinder and
trim cylinder
1. Loosen the tilt cylinder end screw, and
then remove the tilt piston assembly.
CAUTION:
Make sure that the trim and tilt rams are
fully extended before removing the tilt cyl-
inder end screw.
Trim and tilt wrench:
New: 90890-06587
Current: 90890-06548
2. Drain the fluid.
3. Loosen the trim cylinder end screws, and
then remove the trim piston assemblies.
Trim and tilt wrench:
New: 90890-06587
Current: 90890-06548
4. Drain the fluid.
5. Install the trim piston assemblies, and
then tighten the trim cylinder end screws
finger tight.
7-37
Bracket unit
S63P7020
S63P7030
6. Cover the tilt cylinder opening with a
clean cloth 1, and then blow com-
pressed air through the hole a to
remove the free piston 2.
WARNING
Never look into the tilt cylinder opening
while removing the free piston because
the free piston and power trim and tilt
fluid can be forcefully expelled out.
7. Loosen the trim cylinder end screws, and
then remove the trim piston assemblies.
63P3F11