Checking The Cooling Water Passage; Control System; Checking The Engine Idle Speed; Adjusting The Throttle Link And Throttle Cable - Yamaha F80BETL Service Manual

Water
temperature
58–62 °C
(136–144 °F)
above
70 °C (158 °F)
6. Install the thermostat and cover.
7. Connect the cooling water hose, and
then install the flywheel magnet cover.

Checking the cooling water passage

1. Check the cooling water inlet cover 1
and cooling water inlet for clogs. Clean if
necessary.
1
2. Place the lower unit in water, and then
start the engine.
3. Check for water flow at the cooling water
pilot hole. If there is no water flow, check
the cooling water passage inside the out-
board motor.
6D93G11
Valve lift a
0.05 mm
(0.0020 in)
(valve begins to lift)
more than
4.3 mm (0.17 in)
1
S62Y3320
Power unit / Control system

Control system

Checking the engine idle speed

1. Start the engine and warm it up for 5 min-
utes.
2. Attach the special service tool to spark
plug wire #1 1, and then check the
engine idle speed.
1
Digital tachometer: 90890-06760
Engine idle speed: 650–750 r/min
Adjusting the throttle link and
throttle cable
1. Remove the intake silencer.
2. Set the remote control lever to the neu-
tral position and fully close the throttle
lever.
1
2
3
3
4
5
6
S60C3450
7
8
9
3-8