Installing The Drive Shaft; Installing The Propeller Shaft Housing - Yamaha F150A Service Manual

LOWR
2. Apply grease to new oil seals, and then
install them into the drive shaft housing
to the specified depth.
NOTE:
Install an oil seal halfway into the drive shaft
housing, then the other oil seal.
Ball bearing attachment 4:
90890-06633
Driver rod LS 5: 90890-06606
Depth b:
0.25–0.75 mm (0.01–0.03 in)

Installing the drive shaft

1. Install the reverse gear into the lower
case.
2. Install the drive shaft housing 1, thrust
bearing 2, and original shim(s) 3 onto
the drive shaft 4.
CAUTION:
Add or remove shim(s), if necessary, if
replacing the drive shaft housing or drive
shaft.
6-49
Lower unit
3. Install the sleeve, drive shaft, and drive
shaft housing into the lower case, then
the pinion and pinion nut, and then
tighten the nut to the specified torque.
NOTE:
Install the drive shaft by lifting it up slightly,
then aligning it with the pinion and the spline
of the drive shaft.
Drive shaft holder 6 5: 90890-06520
Pinion nut holder 6:
New: 90890-06715
Current: 90890-06505
Pinion nut:
93 N·m (9.3 kgf·m, 68.6 ft·lb)

Installing the propeller shaft housing

1. Install the original shim(s) 1 and propel-
ler shaft housing assembly 2 into the
lower case, and then install the straight
key 3, claw washer 4, and ring nut 5.
5
6
S63P6310
63P3F11