Checking The Power Trim And Tilt Motor - Yamaha F150A Service Manual

BRKT
3. Remove the lead holder 1 and rubber
spacers 2 from the stator, and then slide
them away from the stator.
4. Remove the stator 3.
NOTE:
Place a clean cloth over the end of the arma-
ture shaft, hold it with a pair of pliers, and
then carefully slide the stator off of the arma-
ture.
5. Remove the armature from the PTT
motor base.
CAUTION:
Do not allow grease or oil to contact the
commutator.
6. Disconnect the PTT motor lead (sky
blue) 4.
NOTE:
Hold the brush with a screwdriver as shown,
and then disconnect the PTT motor lead (sky
blue).
7-31
Bracket unit
4
S60X7240
7. Remove the screw, disconnect the PTT
motor lead (light green) 5, and then
remove the brushes 6.
CAUTION:
• Do not pull the PTT motor leads out
from the stator.
• Do not touch the bimetal a, otherwise
the operation of the circuit breaker can
be affected.
Checking the power trim and tilt
motor
1. Measure the length of the brushes.
Replace if out of specification.
Brush length limit a:
4.8 mm (0.19 in)
63P3F11