Yamaha F150A Service Manual page 187

NOTE:
• Install the needle bearing with the manufac-
ture identification mark a facing toward the
oil seal (propeller side).
• When using the driver rod, do not strike the
special service tool in a manner that will
force the stopper c out of place.
Driver rod SS 1: 90890-06604
Needle bearing attachment 2:
90890-06610
Bearing depth plate 3: 90890-06603
Depth b:
24.75–25.25 mm (0.974–0.994 in)
2. Apply grease to new oil seals, and then
install them into the propeller shaft hous-
ing to the specified depth.
NOTE:
Install an oil seal halfway into the propeller
shaft housing, then the other oil seal.
Bearing inner race attachment 4:
90890-06640
63P3F11
Propeller shaft housing (counter rotation model)
Depth d:
4.75–5.25 mm (0.187–0.207 in)
3. Install the original shim(s) 5 and thrust
bearing 6 with the propeller shaft into
the propeller shaft housing.
CAUTION:
Add or remove shim(s), if necessary, if
replacing the propeller shaft, thrust bear-
ing, or propeller shaft housing.
4. Install a new taper roller bearing 7 and
the bearing outer race 8 into the propel-
ler shaft housing using a press.
Ring nut wrench 9: 90890-06578
5
6
S63P6540
6-42
1
2
3
4
5
6
7
8
9