CAUTION:
Add or remove shim(s), if necessary, if
replacing the forward gear, taper roller
bearing, propeller shaft housing, thrust
washer, or lower case.
2. Tighten the ring nut to the specified
torque.
NOTE:
• To secure the ring nut, bend one tab a of
the claw washer into a slot in the ring nut.
• Bend all other tabs toward the propeller
shaft housing assembly.
Ring nut wrench 4 6: 90890-06512
Ring nut wrench extension 7:
90890-06513
Ring nut 5:
142 N·m (14.2 kgf·m, 104.7 ft·lb)
Installing the water pump and shift
rod
1. Install the shift rod assembly 1.
63P3F11
Drive shaft and lower case (counter rotation model)
2. Install a new gasket 2, the outer plate
cartridge 3, and dowels 4.
1
2
3
4
5
6
7
8
9
6-50