Equipment - Zoning Control; Equipment - Add / Remove Equipment; Equipment - Reset All Equipment - Lennox iComfort S30 Installation And Setup Manual

ZONING CONTROL
ABOUT
This provides information on unit code, language supported, equipment type
name, control software revision, control model number, control serial number,
control hardware revision, protocol revision number, device product level, 24VAC
average power consumption, 24VAC peak power consumption, compatible
devices list, application code memory size, micro-controller part number, max
number of zones, supported damper types, number of damper positions, zone
temp sensor 1, zone temp sensor 2, zone temp sensor 3 and zone temp sensor 4.
EQUIPMENT NAME
A unique name can be assigned to this component. Name can be up to 29
characters. Name can consist of letters, numbers, special characters and spaces.
ZONES 1 THROUGH 4 TEMP READING CALIBRATION
Allows adjustment to temperature reading displayed on zone thermostat.
RESET ZONING CONTROL
Any installer modifications under the zoning control tab will be reset back to the
factory defaults if the reset zoning control option is used.
ADD / REMOVE EQUIPMENT
This selection allows the installer to add or remove non-communicating equipment
such as outdoor units, humidifiers and dehumidifiers.
RESET ALL EQUIPMENT
Using this option will reset all equipment back to its original factory default settings.
The installer setup sequence will start as well.
27