Fcc Compliance; Replacement Parts - Lennox iComfort S30 Installation And Setup Manual

FCC COMPLIANCE STATEMENT — PART 15.19
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that
may cause undesired operation.
FCC INTERFERENCE STATEMENT — PART 15.105 (B)
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one of the following measures:
S
Reorient or relocate the receiving antenna.
S
Increase the separation between the equipment and receiver.
S
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
S
Consult the dealer or an experienced radio/TV technician for help.
RF EXPOSURE INFORMATION
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. In order to avoid the possibility of exceeding the FCC
radio frequency exposure limits, human proximity to the antenna shall not be less
than 20cm during normal operation.

REPLACEMENT PARTS

®
The following iComfort S30 component parts can be ordered:
Catalog
Component
Number
12X97 HD Display
12X98 Smart Hub
12X99 Mag-Mount
13X01 Wall plate
HD Display Software for non-
12X97V
thermostat devices
12X98V Smart Hub virtual software
60
Remarks
Thermostat interface
Control base
Wall mount for HD Display
Wall plate for Mag-Mount
(use is optional)
HD Display interface software
running on PC using Blues­
tacks or non-thermostat An­
droid tablet running Android
4.3.
Smart Hub Windows 7 based
emulator.