Beep And Delay - Wasp WLP 4170 Programming Manual

The 'Beep Volume' configuration changes the volume of the audible indicator of
the WLP 4170 CCD Scanner.
NOTE: For help in configuring these settings, consult the programming steps on
page 5.
1. Scan "Begin "
2. Scan "Set Beep Volume"
3. Pick a setting from the table at
right, then turn to the back cover
flap and scan the corresponding
two digits. For example: if you
desire no beep, scan 0 and 0 on
the back cover flap
4. Scan the "Finish" barcode on
the back cover flap
5. Scan the "Exit" barcode
Begin
Set Beep Volume
Beep Volume Settings
00 None
01 Lowest
02 Low
03 Medium (Default)
04 Medium-High
05 High
06 High-Medium
07 Highest
Exit
11
Chapter 5

Beep and Delay