Step 3 - Interface Selection - Wasp WRS100SBR Quick Manual

1d ring barcode scanner

Hide thumbs

Table Of Contents

Table of Contents

ATTENTION

1. If either your hand or the Velcro strap is soaking wet, the Laser

beam may automatically light up without touch trigger. The scanner

can still work well in this condition but it will waste battery power,

so it is recommended to dry both your hand and the Velcro strap.

2. The following gloves have been tested to be working with the

touch-activated button: latex examination glove, antistatic glove,

white cotton glove (with or without latex coating), safety glove,

and rubber glove. However, it is still recommended to operate with

bare hand or thin glove to ensure the responsiveness of button.

3. Don't need to tighten Velcro strap too much. Just make the strap fit

your finger so that the scanner will not easily move while being

touched for trigger. We also suggest to release the strap from your

finger for 1 minute after 2 hours of continuous use if your finger

feels uncomfortable.

STEP 2 - BUTTON PREFERENCE

Scan one of below configuration barcodes to determine which

touch-sensing button to enable according to your habit:

. F064$

. F065$

. F066$

Right Button Only

[ For Left-handed User ]

Left Button Only

[ For Right-handed User ]

Both Buttons

- 9 -