Fitting The Boiler Shell - Buderus Logano G215 WS Installation And Maintenance Instructions Manual

Secure the two slotted hinge lobes to the burner door
using one M12 × 25 hexagon bolt for each.
Attach the burner door to the hinge pins using the
hinge lobes.
Close the burner door.
SYSTEM DAMAGE
through leaking burner door.
Tighten the hexagon bolts of the burner
CAUTION!
door evenly.

7.4.4 Fitting the boiler shell

Installing the boiler rear panel
Insert the spacer pins into the rear section.
Tighten the rear boiler panel using nuts on the
threaded pins and spacer pins.
Logano G215 WS - We reserve the right to make any changes due to technical modifications.
Assembling the boiler block
Fig. 33 Attaching the burner door (here: on the right-hand
side)
1 M12 × 25 hexagon bolt
Fig. 34 Spacer pin installation
Fig. 35 Installing the boiler rear panel
7
29