Buderus Logano G215 WS Installation And Maintenance Instructions Manual page 31

Installing the strain relief and the burner cable
SYSTEM DAMAGE
through incorrectly routed burner cable.
Route the burner cable on the hinge
CAUTION!
side.
Allow for sufficient burner cable length
between the burner and the strain
relief, to enable the burner door to be
fully opened and shut.
Push the strain relief into the holes of the lower tie-
bar.
Lay the burner cable on the thermal insulation.
Insert the burner cable into the strain relief.
Secure the burner cable via the strain relief using two
self-tapping screws.
Installing the side panels
Installation of the side panel on the left-hand and right-
hand side is identical (this example: right-hand side
panel).
Push the snap nut onto the angled sheet steel of the
side panel until it locks into the hole provided.
Logano G215 WS - We reserve the right to make any changes due to technical modifications.
Assembling the boiler block
Fig. 39 Installing the strain relief and the burner cable
1 Strain relief
2 Burner cable
A Push the strain relief into the holes of the lower tie-bar.
B Insert and secure the burner cable.
Fig. 40 Inserting the snap nut (here: right-hand side panel)
7
A
B
1
2
31