6
Installation
6.1
Requirements for the installation room
DANGER
– Install the heating system in a frost-free
room.
– Do not store any flammable materials or
liquids in the immediate vicinity of the boiler.
– Never use any chlorinated detergents or
halogenated hydrocarbons (e. g. in
spraycans, solvents and detergents, paints,
adhesives).
– Do not allow too much dust to collect on the
boiler.
6.2
Fitting the boiler
Observe the installation clearances of the combustion air/
flue gas system.
NOTICE
– To protect the connection orifice you must
not remove the styrofoam bottom panel.
– Do not lift the boiler by the drawer.
– Do not remove the transport safety clamps
(see fig. 6) from the drawer at this time.
– Protect the boiler and the combustion
air/flue gas orifice against pollution during
installation.
Remove the packaging materials and dispose of them.
Use the mounting template to mark the drill holes.
Install the wall bracket taking into account the necessary
service clearances.
Remove the transport safety clamps (fig. 6).
Logamax plus GB142-24/30/45/60 - We reserve the right to make any changes due to technical modifications!
Fig. 6
Removing the transport safety clamps
Installation
6
13