Duplex Adf Removal - Lexmark X543 Service Manual

7525-xxx

Duplex ADF removal

Remove the duplex ADF rear cover from the ADF assembly. See
1.
4-87. Save the cover for use on the new ADF unit.
page
Disconnect the ground cable (A) from the ADF assembly.
2.
Disconnect the ADF cable (B) from the ADF card located on the ADF assembly.
3.
Carefully pull the ADF cable and grommet away from the ADF assembly.
4.
Lift the ADF to an upright position.
5.
6. Use a screwdriver to release the right hinge (C) from the flatbed unit.
Remove the ADF assembly.
7.
Note: After installing the new ADF unit, you will need to perform the duplex ADF registration procedure.
See
"Scanner Manual Registration" on page
Service Manual
4-88
A
"Duplex ADF rear cover" on
B
C
3-35.
Previous
Next
Go Back