7525-xxx
Fuser assembly removal
Remove the right cover. See
1.
2.
Remove the left cover. See
Disconnect the two-wire fuser cable (A) from the LVPS.
3.
Position the fuser cable so that it can be pulled through from the front of the printer, and guide the cable to
4.
the front.
Warning: Be careful not to damage the cable by pulling too hard or cutting the cable insulation
Remove the screw (B) on the right side of the frame.
5.
6.
Disconnect the two thermistor cables (C) from the fuser.
Service Manual
4-28
"Right cover removal" on page
"Left cover removal" on page
4-7.
4-4.
Previous
Next
Go Back