Printhead removal
Remove the scanner assembly.
1.
2.
Remove the top cover. See
Disconnect the cables.
3.
Remove the toroid (A) from the ribbon cable.
4.
Remove the three screws (B).
5.
6.
Remove the printhead.
Installation note:
When the printhead is replaced, perform the registration (black planes) and alignment (color planes). See
"Registration" on page 3-4
See"Flatbed removal" on page
"Top cover assembly removal" on page
B
and
"Alignment" on page
3-7.
4-77.
4-9.
Repair information
7525-xxx
Previous
Next
Go Back
4-61