7525-xxx
Unless the menu is in DIAGNOSTICS, Check Config ID displays.
•
To set the configuration ID:
Select PRINTER SETUP from DIAGNOSTICS, and press Select (
1.
Select Configuration ID, and press Select (
2.
The current value for Configuration ID 1 appears with the left character or digit underlined.
Enter the Configuration ID 1.
3.
Change the left character or digit first.
•
To change a character or digit, press
•
press Select (
To move to the next character or digit, press
•
When you press Select (
•
If Invalid ID appears, the entry is discarded, and the previous Configuration ID 1 is displayed on the
screen.
If the process is successful, Submitting Selection appears on the display, followed by the current
value for Configuration ID 2.
Repeat the steps for entering the Configuration ID 2, and press Select (
4.
If the Configuration ID 2 is validated, Submitting Selection appears, and a check ( ) appears next to
Printer Setup.
Restart the printer. A POR is not automatically performed.
5.
ITU Barcode
The 16-digit numeric value matches the ITU installed in the printer. If you replace the ITU, re-enter this value.
Stop (
) exits the menu.
To enter the ITU barcode:
Select PRINTER SETUP from Diag Menu, and press Select (
1.
Select ITU Barcode, and press Select (
2.
To enter the 16-digit numeric value:
3.
Use
to the next digit. If a digit is already correct, press Select (
When the last number is entered and you press Select (
the entered number is incorrect, Check Sum Does Not Match displays. Check and re-enter the
number.
Enable Edge to Edge Copy
This setting is set to either on or off. Off is the default setting.
Service Manual
3-20
).
) on the last digit, the value will be submitted.
to decrease the leftmost digit value or
).
).
to decrease or
to increase the underlined value, and
or
, and press Select (
).
).
to increase the value. press Select (
) to accept the number and to continue.
), Submitting changes... should appear. if
).
.
)
) to advance
Previous
Next
Go Back