Lexmark X543 Service Manual page 61

Service error messages (1XX, 8XX and 9xx) (continued)
Error code Description
109.02 Service The black printhead failed to complete
Black Printhead servo.
109.03 Service The black printhead mirror motors
Black Printhead failed to achieve lock.
109.04 Service The black printhead mirror motors lost
Black Printhead PLL motor lock.
109.05 Service Failure reading NVRAM from
Black Printhead printhead.
109.08 Service The black laser showed bad in EMS
Black Printhead testing.
109.11Service Failure writing data to printhead
Black Printhead
109.12 Service Failure reading data from the printhead
Black Printhead
109.13 Service Printhead declared error
Black Printhead
122.xx Service Fuser error
Fuser Error
122.01 Service EWC error—Attempting to print with
Fuser Error estimated power at or below minimum
power.
122.02 Service Fuser over temperature.
Fuser Error
122.03 Service Fuser open thermistor check failed.
Fuser Error
122.04 Service EWC Error—Did not reach EWC start
Fuser Error temperature in time.
122.05 Service EWC Error—Did not change
Fuser Error temperature within expected time.
122.06 Service EWC Error—Did not reach EWC stop
Fuser Error temperature in time.
930.09 Service Fuser zero crossings out of range.
LVPS Zero crossing detected.
122.10 Service Fuser failed to warm up.
Fuser Error
122.11 Service Fuser under temperature error while in
Fuser Error standby.
122.12 Service Fuser under temperature error while
Fuser Error printing.
Action
Perform a POR. If the problem persists, go
to
"Printhead service check" on
page 2-60
Perform a POR. If the problem persists, go
to
"Printhead service check" on
page 2-60
Perform a POR. If the problem persists, go
to
"Printhead service check" on
page 2-60
Perform a POR. If the problem persists, go
to
"Printhead service check" on
page 2-60.
Perform a POR. If the problem persists, go
to
"Printhead service check" on
page 2-60.
Perform a POR. If the problem persists, go
to
"Printhead service check" on
page 2-60.
Perform a POR. If the problem persists, go
to
"Printhead service check" on
page 2-60.
Perform a POR. If the problem persists, go
to
"Printhead service check" on
page 2-60.
Go to
"Fuser service check" on
page 2-42.
Go to
"Fuser service check" on
page 2-42.
Go to
"Fuser service check" on
page 2-42.
Go to
"Fuser service check" on
page 2-42.
Go to
"Fuser service check" on
page 2-42
Go to
"Fuser service check" on
page 2-42
Go to
"Fuser service check" on
page 2-42
Go to
"Fuser service check" on
page 2-42.
Go to
"Fuser service check" on
page 2-42.
Go to
"Fuser service check" on
page 2-42.
Go to
"Fuser service check" on
page 2-42.
Diagnostic information
7525-xxx
Previous
Next
Go Back
2-17